Basic FX
Fresh Bruise
I created this intravenous user type bruise by alternating layers of glaze gels and airbrush paint.
After
Before
Healing Bruise
I created this intravenous user type healing bruise by alternating layers of glaze gels and airbrush paint.
After
Before
Scar
This smallpox vaccine scar was created using rigid collodion, matted Pros-aide, and colored with Copic marker
After
Before
1st Degree Burn
I created this quick 1st degree burn by doing a base color with glaze gels, then covered the area in a sheet of Baldiez, blended out, then colored it with alcohol paints and Copic marker.
Before
2nd Degree Burn
This particular 2nd degree burn was created first by laying down some washes of color with glaze gels, then creating a blister perimeter with Telesis, putting a blister gel in the palm and then putting a piece of Baldiez over the blister, trying to get some tension on it. I then used acetone to blend off and break open the blister to give it a ruptured effect. Lastly, I completed the look with KY jelly.
Before
Cuts
These cuts were simulated using silicone appliances, with matted Pros-aide along the edge to tie in the texture. It was painted with alcohol paints and Copic markers.
After
After
Before
Scab
This scab was created by putting down and initial wash of color, going over that same area again with rigid collodion, then again with a mixture of Pros-aide and Solka Floc. Once that dried, I colored into it with Copic markers.
After
After
Before